![]() ![]() Then when it’s done, I can turn it off, swap the drive, and boot to HeXEn again and do a clean install. Then put it back together and boot to HeXEn and flash it. Then I would take out the board, solder the points on top and bottom of the board. My understanding is I need to leave the HeXEn disc in the drive before I begin. What are the thoughts and/or dangers on this? Wouldn’t the only potential problem be another flashing? Third, I’ve heard that after you TSOP flash, you should remove the jumpers to avoid accidental damage. ![]() Second, I know I have a 1mb TSOP (mine is the ST.) Can someone recommend a bios? I don’t plan to use more than one, So this is going to sound dumb but, will it still boot from dvd (for HeXEn?) I have a small list of questions, hopefully I can get answered first.įirst, I read somewhere on here (I think under the HeXEn 2018 post), that some of the bios have the dvd check turned off by default. ![]() But I’m thinking that before putting the drive in, I’d like to try TSOP flashing it, then doing a clean install with HeXEn 2018. I also picked up a 2TB HD, SATA adaptor, and 80 wire IDE cable. It is v1.1 and have already softmodded it. I haven’t had an Xbox for the last couple years and I decided I miss them. Up til now I have only softmodded Xboxes, and it has been quite a while.
0 Comments
Leave a Reply. |